Hobbywing EZRUN Max6 ESC Enclosure for Trampa Holypro 35

Hobbywing EZRun Max6 Enclosure - Electric Mountainboard

I designed a custom enclosure to fit two Hobbywing EZRun Max6 ESC and a parallel connector on a Trampa Holypro 35. The case is pretty tight and uses the trucks’ screws to be attached to the deck. The ESC’s fans are outside and the wires are inside, the connectors are well protected. There is just enough room to fit a micro/nano receiver and a Parallel hub for XT90, it won’t fit if you use this kind of cables.

There are a bottom part and a top part that is maintained already by just clipping the top to the bottom but 2 screws are also used to ensure the part will not move. The ESCs are maintained by the top part, but I added some double face tape to fix them.

To assemble this enclosure, you would need:

  • Bottom part
  • Top part
  • TPU Seal for 10AWG silicone wires
  • 2 x M4 35mm socket screw
  • 2 x M4 Nyloc Nuts

Leave a Reply

%d bloggers like this: